ET Series 24V96W ELV/MLV Phase Dimming LED Driver

96W Phase-Cut Dimmable LED Driver — 24V Constant Voltage
This North American indoor power supply accepts 120V AC input and delivers regulated 24V DC output at 96 watts, making it ideal for driving extended runs of LED tape, discrete modules, and linear bar fixtures from a single source.
The integrated junction box and low-profile iron housing streamline hardwired installation into standard electrical boxes, eliminating the need for separate enclosures or mounting accessories. IP20 ingress protection ensures reliable operation in dry, protected indoor environments.
Certified to ETL and cETL Class 2 standards, the driver meets stringent safety requirements for limited power circuits while delivering exceptional phase-cut dimming compatibility with mainstream wall dimmers. Efficiency performance reaches 90% and above, complying with US Level VI energy regulations to minimize operating costs and thermal output.

Features:

． Super compact IRON CASE

． ETL/cETL Class 2 RoHS

． IP20 - Indoor Use

． Auto-Reset Protection for input/output overvoltage protection, input/output overcurrent protection, over temperature protection, over power protection and short circuit protection

Specification:

Input Voltage            120V AC  60Hz                           

Output Voltage            24 Volt                                  

Operating Temperature     -20℃-45℃(-4℉-101℉)  

Mode                           Constant voltage   

Dimensions (inch)         7.88"×3.35"×1.46"        

Weight                  520g        

12/24-Volt DC Installation Guide

Highly efficient, stabilized, constant voltage DC power of LED lighting

General
- This driver is to be installed in accordance with Article 450 of the National Electric Code and installed by qualified and professional electrician;
- Please make sure the driver is installed with adequate ventilation around it to allow for heat dissipation.

Before Installing
- Power must be disconnected at all times during installation.
- Observe polarity of the 12/24-volt DC output. Failure to observe polarity could damage LED lighting.
- Total wattage of all LED fixtures used must not exceed the maximum watt rating of the power supply.

Input Connections / Grounding
- Use the clamp connectors to secure cords and wires.
- Route and secure wires so they will not be pinched or damaged.
- All wiring must be in accordance with national and local electrical codes, low voltage Class 2 circuit. For wire runs inside of walls, use properly certified CL2 or better cabling and appropriate mounting hardware. If you are unclear as to how to install and wire this product, contact a qualified electrician. Failure to install this device properly may result in electrical shock or fire.
- Do not install Class 2 low voltage wiring in the same runs as AC main power. If AC and low voltage wires cross, keep them at 90-degree angles.
- The driver case MUST be grounded in accordance with the N.E.C. Connect the ground wire to the driver green wire.

Output Wire
- Bring the wires of the light fixture through the other clamp connector and connect them to the driver wires - positive to the red (+) wire and negative to the blue (-) wire

Package